Resource id #229 Крыши домов. Крыша на дом 10 на 10. Крыша деревенского дома. Крыша дома 5 на 5.
крыша дома 5 на 5

крыша дома 5 на 5

загородный дом

Dismantle an amortisation rack. Clamp an amortisation rack for вильчатую a head in a vice. Never tighten in the field of a cylindrical detail, differently the amortisation rack will be squeezed. Establish the tension device on coils of a spring and slightly compress a spring. That tension devices have not slid off, paste over corresponding coils of a spring with a sticky tape. Loosen the a nut with a flange above an amortisation rack. By means of a key with internal шестигранником wring out in an opposite side a rod of the piston of the shock-absorber. Remove a spring with auxiliary details. Remove a protective cap and a lining under a spring. Separate a spring plate a plastic hammer and remove it. Installation: put on a spring plate the new shock-absorber. Pay attention to assembly position: the aperture should be in a spring plate with displacement in 90 ° in relation to apertures in вильчатой to a head below on the shock-absorber (a maximum deviation only 2 °). Establish a lining under a spring, a protective cap and a cover, and also the persistent shock-absorber. Establish on a plate a spring which is still under a tension; track that the bottom end of coils of a spring adjoined to an emphasis of a plate of a spring. Put on the top plate of a spring with the bearing of an amortisation rack and a washer. Twirl a spring plate according to drawing on 11 ° to an axis of screwing up of the shock-absorber (below at вильчатой heads). On right and a left-hand side different directions. Work precisely: the admission is made only 2 °. Tighten a nut with a flange above on an amortisation rack on 60 Nanometers. By means of a key with internal шестигранником wring out in an opposite side a rod of the piston of the shock-absorber. Loosen the a spring tension, thus track that the spring end adjoined to an emphasis of a lining of a spring.

Новости категории ‘Гуппи’ Как узнать самку гуппи? По форме анального плавника : у самцов он острый, вытянут в трубочку, а у самок круглый. А по яркости окраски… маловероятно. У современных гибридных гуппи, самки нисколько от самцов не отличаются по яркости и разнообразию расцветок. Самец ярче. Как правило в аквариуме всегда бросаются в глаза разноцветные самцы с большими плавниками и хвостом. Самки на их фоне серые мышки. Они больше самцов и серого цвета, а самцы меньше с красивыми хвостиками. Спутать их невозможео, так как они намного крупнее сацов и не такие цветастые.